1998 PONTIAC BONNEVILLE 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger TAN DR. (-) (-) DK.BLU PASS AT BCM PASS. KICK DIODE ISO
TrunkTrigger ORG/BLK (-) (-) AT HARNESS FROM TRUNK LID
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK OR AT BCM MOD PASS SIDE
ParkingLights BRN (+) (+) HEADLIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSKEY
KeySense LT.GRN (-) IGNITION SWITCH HARNESS
Tach WHT (-) (-) PASS FRONT OF ENG UNDER COIL
ParkingLights BRN (+) (+) HEADLIGHT SWITCH
BrakeLights LT.BLU (+) (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) DRIVERS SIDE OF TRANSMISSION
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLK (-) (-) NEGATIVE TRIGGER
PowerLock RED/BLK (-) (-) DRIVER'S KICK PANEL OR AT BCM PASS KICK
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU LR:GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO
Convenience
HeadLights WHT (-) (-) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT WIPER SWITCH
TrunkRelease BLK (-) (-) TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
PowerAntenna POWER
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
